13
normal mode.
2. With the base station turned off, press and hold the power supply button for 3s to enter into the
disabled RTK mode. You will hear 3 beeps when entering into the mode, and the RTK indicator
will be red.
Turn off
Press and hold the power supply button for 1s to turn off.
connect the ground station or aircraft
Using the normal mode as example, the specific operations are as follows:
A. Frequency pairing of the base station with the aircraft
1. Click the base station frequency pairing button. The frequency pairing indicator will flash;
2. Press the frequency pairing button in the rear battery compartment of the aircraft to enable the
aircraft to enter into the frequency pairing state. The aircraft fuselage frequency pairing indicator
will flash quickly during the pairing process.
3. After frequency pairing succeeds, the frequency pairing indicator on the base station will flash
in red at frequency of 0.1s/2.0s
B. Connect ground station to base station
1. Turn on the base station power supply;
2. Turn on the remote controller and run the Autel Voyager App, select "Settings -> Base Station."
After entering, when you see the base station WiFi hot spot, enter the password: 12345678, wait
for seconds till the remote controller: is successfully connected with the base station;
3. Exit the setting interface, enter the task flight interface, click the gear icon in the upper right
corner, enter the setting menu, click "Remote controller" to open the option "Base station use
connection".
Description of image transmission state indicator
Green light 1.5s/1.5s slow blinking flash
Image transmission is not connected
Green light 0.1s/0.1s rapid blinking flash
In image transmission frequency pairing
Green light 0.1s/2.0s blinking flash
Image transmission is normally connected
Green light 3s/0.2s blinking flash
In upgrade data downloading
Normally on green
In firmware update