IMGC450
INSTALLATION AND OPERATION MANUAL
4
INSTALLING SHOCK MOUNT &
IMGC450 MICROPHONE
The shock mount is designed to be flush-mounted and
provides isolation to reduce room-rumble and mechanical
noises from being amplified.
Installing the Shock Mount
Choose a suitable flat surface to install the shock
mount.
Using a hole saw cut a 51mm (2inch) diameter
hole through the mounting surface
Slide the shock mount into the freshly cut hole
and mark the location of the three screw holes
using a marker or punch.
Using a 3.0mm drill pre-drill three pilot holes.
Insert the shock mount into the hole again and
fasten down the shock mount with the 3 screws
provided.
Installing IMGC450 into the Shock Mount
To install the IMGC450 into the Shock Mount
unscrew the bottom plastic screw collar.
Slide the IMGC450 body into the Shock Mount.
Re-install the bottom plastic screw collar until snug.
Be careful not to cross thread or crack the plastic
screw collar.
Insert a female 3-pin XLR connector into the
microphone base.
Phantom power is required for the IMGC450
to operate.
To avoid possible loudspeaker damage ensure
the PA system is muted first before you enable
phantom power.
1
1
2
2
3
3
4
4
5
5
6
7
