Important Safety Information
1.
Save the carton and packing material even if the equipment has arrived in good condition.
Should
you ever need to ship the unit, use only the original factory packing.
2.
Read all documentation before operating your equipment.
Retain all documentation for future
reference.
3.
Follow all instructions
printed on unit chassis for proper operation.
4.
Do not spill water or other liquids into or on the unit,
or operate the unit while standing in liquid.
5.
Make sure power outlets conform to the power requirements
listed on the back of the unit.
6.
Do not use the unit if the electrical power cord is frayed or broken.
The power supply cords should
be routed so that they are not likely to be walked on or pinched by items placed upon or against them,
paying particular attention to cords and plugs, convenience receptacles, and the point where they exit from
the appliance.
7.
Always operate the unit with the AC ground wire connected
to the electrical system ground.
Precautions should be taken so that the means of grounding of a piece of equipment is not defeated.
8.
Mains voltage must be correct and the same as that printed on the rear of the unit.
Damage caused
by connection to improper AC voltage is not covered by any warranty.
9.
Have gain controls on amplifiers turned down during power-up
to prevent speaker damage if there
are high signal levels at the inputs.
10.
Power down & disconnect units from mains voltage before making connections.
11.
Never hold a power switch in the “ON” position if it won’t stay there itself!
12.
Do not use the unit near stoves, heat registers, radiators, or other heat producing devices.
13.
Do not block fan intake or exhaust ports.
Do not operate equipment on a surface or in an
environment which may impede the normal flow of air around the unit, such as a bed, rug, weathersheet,
carpet, or completely enclosed rack. If the unit is used in an extremely dusty or smoky environment, the
unit should be periodically “blown free” of foreign matter.
14.
Do not remove the cover.
Removing the cover will expose you to potentially dangerous voltages.
There are no user serviceable parts inside.
15.
Do not drive the inputs with a signal level greater than that required to drive equipment to full
output.
16.
Do not connect the inputs / outputs of amplifiers or consoles to any other voltage source,
such as a
battery, mains source, or power supply, regardless of whether the amplifier or console is turned on or off.
