6
INSTALLATION SERIES
Australian Monitor
3. BACK PANEL
1. INPUT A/B CONNECTORS
2. OUTPUT CONNECTORS
3. 24VDC POWER CONNECTOR
4. EARTH Stud
The balanced XLR inputs can be used as Mic or Line level inputs and are switched
between input sensitivities via internal DIP switches accessed through the lid (see internal
adjustments section page 7). The dual RCA inputs are Line level inputs only and are
internally summed to mono.
The AMIS26's outputs can be either balanced XLR or unbalanced dual RCA's. Both these
outputs can be switched between Mic level & Line level via internal DIP switches accessed
through the lid (see internal adjustments section page 7).
This 2.1mm connector accepts power from the provided 24VDC power supply.
In some circumstances it may be necessary to ground the unit to eliminate noise in the
system. This can be done by using this earth stud.
OUTPUT 6
OUTPUT 5
OUTPUT 4
OUTPUT 3
OUTPUT 2
OUTPUT 1
INPUT B
INPUT A
EARTH
DC INPUT
+24VDC
+ve
ENGINEERED BY AUDIO TELEX COMMUNICATIONS PTY LTD IN SYDNEY, AUSTRALIA
XLR
1 = Ground
2 = + Signal
3 = - Signal
RCA & XLR OUTPUTS ARE INTERNALLY SWITCHABLE BETWEEN MIC/LINE LEVEL
RCA INPUTS ARE LINE LEVEL
XLR INPUTS ARE INTERNALLY SWITCHABLE BETWEEN MIC/LINE LEVEL
1
2
3
PIN 2
HOT
+
PIN 3
COLD
-
PIN 1
GND
PIN 2
HOT
+
PIN 3
COLD
-
PIN 1
GND
FEMALE XLR
MALE XLR
4
NOTE:
This stud provides a connection to chassis ground. Audio ground is internally
tied to chassis ground.
