1300 100 120
•
Check for bends, nicks, wear, stretching or elongation of
the components.
•
Check for any signs of corrosion.
•
Check for any scoring or cracks on all welds and components.
•
Check the latch, rivet and spring. Latch shall be working
properly.
Inspection
Make sure all areas to be welded are cleaned and free
The surface to be welded should be preheated. Ensure
First position the lifting point then tack weld all four
around. Make sure the lifting point is welded to the
To reach maximum penetration, ensure that the welding
It is recommended that you weld the top joint of the
Ensure that there are no cracks or pores in the welds
Allow the weld to cool at room temperature. Do not
All bare and unwelded areas should be painted to
All moving parts should be well lubricated after welding.
MIG welding has less penetration than others and it is
Triple weld runs may have to be conducted in
order to reach minimum weld fillet area (A).
WARNING
The components should be taken out of service immediately if
it shows any of the above faults.
A
