1300 663 868 | [email protected] | aussietraveller.com.au
BRISBANE SHOWROOM:
11-15 Oasis Court, Clontarf QLD 4019 |
MELBOURNE SHOWROOM:
235 Barry Road, Campbellfield VIC 3061
4
OPERATING THE 12V DROP DOWN STEP
The Aussie Traveller 12 Volt Drop Down step is operated by the supplied in/out switch, mounted as per the
installation instructions.
IMPORTANT:
When operating the step, hold the switch in the OUT position until the step is
completely extended.
Never use the step unless the vehicle is in a secure, stationary position.
Ensure the step is fully retracted before the vehicle is to depart.
NEVER STEP ON TO THE FOOTBOARDS IF THE STEP IS IN OPERATION,
NOT FULLY EXTENDED OR IS RETRACTED. THIS COULD CAUSE INJURY
AND FAILURE OF THE STEP.
MAINTENANCE:
Dirt, dust, water and frost can prevent the step from operating correctly. Ensure that step is cleaned regularly and
dried if water is used. Never use harsh chemicals or brushes to clean the step.
IN CASE OF MOTOR OR ELECTRICAL FAILURE:
1. With power turned off, loosen indicated bolt and take out.
2. Once step has manually been retracted back into correct position, replace the bolt and tighten back up.
Figure 1.
Bolt to be removed location.
Figure 2.
Bolt location, closer view.
Figure 3.
Bolt picture.
