2.
CARING FOR YOUR TONNEAU
-
Apply bee's wax or Dri-lube to stitching a few times a year, as this will maintain the tonneau's
waterproofing ability and prevent the stitching from degrading. Use a mild detergent and soft
scrubbing brush to clean tonneau.
-
Never drive without tonneau support bars in place as flapping can cause a delaminating effect
on the material.
"Tonneau is not designed to be used as a load restraint"
3.
MULTI-FIT SUPPORT BAR
The Aussie Tonneau Multi - Fit Support Bar is designed to fit almost all Utes on the Market, from Suburu Brumbys
to Cab Chassis aluminium trays.
3.1 BASIC TOOL REQUIRED
Drill, 4mm drill bit
3.2 MULTI-FIT SUPPORT BAR CONTENTS
-
1 x hollow bar centrepiece
- 2 x grub screws
-
2 x solid bar end piece
3.3 FITTING MULTI-FIT BAR
1.
Insert solid bar pieces into either end of hollow tube. Adjust bar so it fits between bar bracket holders
with the holes facing to the ground (so the grub screws don’t rub against the tonneau), as shown above
and then with a white pencil make a mark through the small holes of the hollow bar onto the solid ends.
This is where you will drill a hole to the depth of about 1-2mm (do not go any further)
Figure 4
Thread Rope through
each of the eyelets
