Ausrv AUSRV LX 2021, Руководство пользователя

Страница: 53 / 104

www.ausrv.com
Ph: 833 872 8778
53
Operating Procedures
Risk of damage in frost conditions.
In frost conditions, ambient temperatures below 39 °F (4 °C), there is a risk that
water in pipes, faucets and appliances could freeze. This can cause considerable
damage.
•
Before you fill water into appliances and parts that transport water, you
must heat the installation area sufficiently so that the water cannot
freeze.
NOTICE
Proceed as follows to fill the appliance with water:
1. Close open bypass lines (if present). Insert the water inlet filter or heating cartridge – if removed. 2, 7, 9 – 11.
2. Turn on fresh water supply or switch on water pump.
3. Fill the plumbing system.
• Open all water-release points, e.g., cold and hot water faucets, showers, toilets.
It is important that you bleed the water system before starting the appliance. Once water flows, the plumbing
system is vented. Close the water-release points.
4. Start the appliance as follows:
Make sure that the LP gas supply is turned on.
Switch on the 12 V power supply (RV).
Open the access door (refer to “Opening the access door” on page 50).
Switch on the appliance at the POWER switch. Refer to “Switching ON the appliance” on page 54.
5. AquaGo comfort / AquaGo comfort plus:
Select the desired operating mode (refer to “Operating modes (control panel)”
Close the access door (refer to “Closing the access door” on page 51).
Scalding injuries caused by hot water!
Water temperatures over 127ºF (52ºC) can cause severe burns or scalding and in
extreme cases even death.
•
Before using the hot water faucet or using the shower, allow the hot
water to run until the water temperature no longer increases.
• Test the temperature of the water before placing a child in the bath or
shower.
• Do not leave a child or an infirm person in the bath unsupervised.
WARNING