How to Install Yuno board to YUNO-K215-BLACK
How to Install or Remove the Mylar
1. Mylar x 8 units is located in the accessory box
.
2. There are 8 places where the mylar can be added (see below)
.
3. To install the mylar simply place it over one of the holes
.
4. To remove the mylar, use a pointy object to dislodge it
.
7
Add M/B to module.
3
Turn and tighten the thumb screw.
4
Add the cover to module.
6
Place thermal pad onto the heat sink and
remove the second side of the protection.
2
1
Take the thermal pad from accessory box,
and remove one side of the protection.
Connect 40pin eDP cable to MB 40pin
connector.
5