RTX-24EM-HP
User guide
The technical characteristics can change without notice. AUR°EL S.p.A doesn’t assume the responsibility to the damages caused by an improper use of the device.
AUR°EL S.p.A.
Via Foro dei Tigli, 4 - 47015 Modigliana (FC) – ITALY 12/11/2019 - Rev. A
Tel.: +390546941124 – Fax: +390546941660 Page 17
http://www.aurel.it
Reset_Micro
This instruction allows an asynchronous reset of the microcontroller. Never use this command when the
micro is running (RAM2 and FIFO’s content could be corrupted). Always first stop the micro using SPI
command Stop_Micro prior to use Reset_Micro.
Stop_Micro
This command stops the microcontroller.
Start_Micro
This command start the microcontroller and executes the program currently stored in RAM1.
Clear_IRQ
Use this command to reset the IRQ signal. It works only when microcontroller is running.
Send_TXFIFO
This command will send the current contents of the TXFIFO. Depending on the selected subroutine, the
program either sends the full content of the FIFO, or the number of bytes specified in RAM2.
Aux_com
This command allows the Channel RSSI to be read and stored to Limit_RSSI[3:0].
