RPT 230 / RPT 12
R E P E A T E R
User Manual
The AURATON RPT repeated is a device that repeats the signal emitted by a
transmitter to the receiver, without any modification of the signal, in order to
increase the range of the transmitter's radio transmission range.
This is done,
for example, in manufacturing buildings where the receiver is out
of the transmitter's range or in multi-floor buildings where thick walls hinder
transmission between the transmitter and the receiver.
Principles of operation of the AURATON RPT
AURATON RTH
Receiver
Transmitter
max. 30m
(indoor)
AURATON RTH
Receiver
Transmitter
max. 30m
(indoor)
AURATON RPT
max. 30m
(indoor)
Repeater
AURATON RPT
It is possible to build chains consisting of up to 8 repeaters. Each AURATON RPT
repeater automatically receives the signal from another repeater and forwards
it without any additional user settings.
AURATON RTH
AURATON RPT
Repeater
AURATON RPT
Repeater
max. 8 pcs
AURATON RPT
button for unpairing devices
button for pairing devices
with the repeater
diode indicating operation
of the device
cable fixture
power supply connection terminal
230 V AC or 12 V DC*
key
Green continuous light
–
the repeater is waiting for a data packet
.
Green blinking light
–
the repeater is waiting for device pairing
-
(
chapter: "Pairing of LMS devices with the AURATON RPT repeater"
).
Red blinking light
–
the repeater is waiting for a device to unpair
-
(rozdział: „
chapter: "Unpairing
of devices from the AURATON RPT
repeater"
”).
Alternating red and green light for 1-2 seconds
–
the repeater
receives/sends a data packet.
Alternating red and green light
:
ALARM -
the repeater's connection with one of the paired devices is
broken. If AURATON RPT does not receive a data packet from
a paired device for 35 minutes, then it indicates this with
alternating red and greed diode light.
RESET -
the repeater unpairs all the previously paired devices -
(chapter: "RESET - Unpairing all devices paired with the
AURATON RPT repeater")
Key - description of diode signaling
hole for the screw fixing
the repeater to the wall
hole for the screw fixing
the repeater to the wall
Description of the AURATON RPT 230/12
repeater
IN
OUT
ALARM
RESET
ALARM
35
RX/TX
min
IN
OUT
ALARM
RESET
35
min
1
.
Take off protective covers from the
lower and upper part of the
AURATON
RPT
.
AURA
TON RPT
Fastening the AURATON RPT repeater.
protective cover
NOTE:
When installing the AURATON RPT repeater its power
supply must be disconnected. It is recommended that
the installation is performed by a qualified specialist.
NOTE:
The permanent electrical system of a building must
include a breaker and an overcurrent protection.
2
.
3
.
4
.
Take off cable tie clamps from the lower
and upper part of the
AURATON RPT
.
Connect power supply conductors to the
power supply terminals
of the
AURATON RPT
, observing safety rules
After connecting the conductors, they
must be secured with the cable tie
clamps and reinstall protective covers of
the
AURATON RPT
.
ALARM
35
min
AURATON RPT 230
cable tie clamp
AURATON RPT 230
ALARM
35
min
RX/TX
~230 VAC
(AURATON RPT 230)
12 VDC
(AURATON RPT 12)
*
Receiver
