
S W - 3 7 7 W
AURA
2 Solar Frosted
Dome Lights
The solar light comprises of a solar cell,
rechargeable batteries and LED light
source. Light from the sun charges the
batteries during the day and at night the
energy stored in the batteries is used to
power the light.
The length of time the light stays on for
is dependent on the amount of sunlight
the solar panel has been exposed to
during the day.
No other power source or connections
are required.
PACK CONTENTS
•
2 x Solar light units (A)
•
2 x Post pipe in 27cm (B)
•
2 x Connectors (C)
•
2 x Post pipe in 20cm (D)
•
2 x Ground spikes (E)
WARNING
Do not apply pressure to the solar panel.
PRIOR TO USE
Check the pack contents to make sure you
have all the products listed.
Set power switch to "OFF" position and allow
battery to charge for 2 days under full sunlight.
Repeat this procedure every three months to
top up the battery. Please note, this may take
longer if there is not constant full sunlight.
Decide on an appropriate location for your
product (see Siting Instructions opposite)
ASSEMBLY INSTRUCTIONS
1
Insert Solar light unit into 27cm post pipe
2
Then insert connector piece into 27cm
post pipe
3
Push 20cm post pipe onto connector piece
4
Insert ground spike into free end of 20cm
post pipe
SITING INSTRUCTIONS
Solar lights are designed for use outside in an
open (un-shaded) location
The solar light should be located where sunlight
can fall directly on the unit. Shadows from
buildings, trees, walls, hedges or similar should
be avoided as these will reduce your light
running time.
Avoid locations where light from other sources
will fall on the panel at night (street lights,
floodlights etc) as this may prevent the light from
turning on.
The units can be left outside in the rain but
should not be exposed to water jets or
immersed in any way.
For optimum life, the solar panel should be
protected from weather extremes such as snow
or frost
Do not position near direct sources of heat such
as patio heaters or barbeques
The Solar panel is designed to be placed where
the ground is soft so that the ground spike can
be pushed in easily.
CARE & USE
Periodically wipe clean with a soft dry cloth.
Never use scourers, abrasives or chemical
cleaners. Do not allow water to come into
contact with electric components.
The solar panel lens should be cleaned
periodically to ensure its efficiency is not
reduced by dust and dirt.
Some condensation may form inside the lights
or solar panel in cold conditions. This is normal
and will not affect the performance of your light.
1
A
B
C
D
E
X 2
Prior to first use, set power switch to ìOFFî position and fully charge the battery for 2 days under
full sunlight. Repeat this procedure every three (3) months to fully recharge the battery.
Environmental Protection
Waste electrical products should not be disposed of with household waste. Please
recycle where facilities exist. Check with your Local Authority or retailer for recycling
advice.
NiCd battery must be recycled or disposed of properly.
SW377W
2
1
0
m
m
INSTALLATION
4
CHARGE
5
BATTERY REPLACEMENT
3
LOCATION
2
WARNING
148.5mm
Cd
A5 210MM X 148.5MM
Manual
08 Nov 06
+
-
OFF
POWER
AUTO
OFF
POWER
AUTO
1.2V / 600mAh NiCd
1
2
1
A
B
C
D
E
X 2
Prior to first use, set power switch to ìOFFî position and fully charge the battery for 2 days under
full sunlight. Repeat this procedure every three (3) months to fully recharge the battery.
Environmental Protection
Waste electrical products should not be disposed of with household waste. Please
recycle where facilities exist. Check with your Local Authority or retailer for recycling
advice.
NiCd battery must be recycled or disposed of properly.
SW377W
2
1
0
m
m
INSTALLATION
4
CHARGE
5
BATTERY REPLACEMENT
3
LOCATION
2
WARNING
148.5mm
Cd
A5 210MM X 148.5MM
Manual
08 Nov 06
+
-
OFF
POWER
AUTO
OFF
POWER
AUTO
1.2V / 600mAh NiCd
1
2
1
A
B
C
D
E
X 2
Prior to first use, set power switch to ìOFFî position and fully charge the battery for 2 days under
full sunlight. Repeat this procedure every three (3) months to fully recharge the battery.
Environmental Protection
Waste electrical products should not be disposed of with household waste. Please
recycle where facilities exist. Check with your Local Authority or retailer for recycling
advice.
NiCd battery must be recycled or disposed of properly.
SW377W
2
1
0
m
m
INSTALLATION
4
CHARGE
5
BATTERY REPLACEMENT
3
LOCATION
2
WARNING
148.5mm
Cd
A5 210MM X 148.5MM
Manual
08 Nov 06
+
-
OFF
POWER
AUTO
OFF
POWER
AUTO
1.2V / 600mAh NiCd
1
2
PRODUCT SPECIFICATIONS
Product Size
11.4cm (L) x 11.4cm (W) x 60cm (H)
+ 9.5cm (spike)
Solar Cell
0.16W Amorphous
Light Source Type
1 x white LED (per unit)
Laser Classification
Class 1
Surface Material
Stainless Steel
Battery Type
1 x 1.2V NiCd (AA) 600mAh (per unit)
Maximum UK operating Time (summer)
8 hrs
Maximum UK operating Time(winter)
3 hrs
Maximum operating Time (full charge)
12 hrs