CAUTION!
when the flow rate is insufficient, “WATER” will be
displayed in the temperature display, the selected level value will
blink and the heaters will not function. In this case, flow rate must
be raised using the faucet.
5- In order to turn off your water heater, first deactivate the heaters
by pressing the current level button. Then, turn the on/off switch to
“0” position to turn of the water heater completely.
6- Wait for the water temperature to drop. When it does, close the
hydrant. This process prevents the calcification of the resistor and
will prolong its life.
ATTENTION! WHILE USING:
1.In case of a failure, cut the electricity supply by turning off the fuse
connected to the water heater and call the service.
CAUTION!
If “E1, E2, ……..E9” is shown in the display, turn the
water heater off and then on by using the ON/OFF switch. If the
fault is not eliminated, call the service.
2.If the water you use is too hard, it is recommended that you use
anti-lime agents. They can be procured from our authorized
services. Calcification failures are not manufacturing defects and
therefore not under warranty.
3.If the holes in the shower head are obstructed, the filter cover must
be removed and cleaned with lime remover.
4.The front cover of the appliance can be cleaned with a humid cloth
with detergent. (Never use powder detergent, solvents, alcohol,
thinner, gasoline.)
5.Do not block the water outlet by connecting a tap or any other
additional parts (Figure 4).
6. For open outlet water heaters used with spray head and spray head
must be descaled regularly.
Figure 1
Figure 2
Figure 3
