Aura LM-270, Руководство пользователя

Страница: 4 / 30

Like all power tools
,
there is danger associated with this
Metal Bandsaw
.
Accidents are frequently caused by lack of
familiarity or failure to pay attention
.
Use this tool with
respect and caution to lessen the possibility of operator
injury
.
If normal safety precautions are overlooked or
ignored
,
serious personal injury may occur
.
No list of safety guidelines can be complete
.
Every shop
environment is different
.
Always consider safety first
,
as it
applies to your individual working conditions
.
Use this and
other machinery with caution and respect
.
Failure to do so
could result in serious personal injury
,
damage to
equipment or poor work results
.
Site Considerations
Lighting and Outlets
Lighting should be bright enough to eliminate shadow
and prevent eye strain. Electrical circuits should be
dedicated or large enough to handle combined motor
amp loads. Outlets should be located near each machine
so power or extension cords are not obstructing high-
traffic areas. Be sure to observe local electrical codes for
proper installation of new lighting, outlets, or circuits.
Read the manual before assembly and operation.
Become familiar with the machine and its operation
before beginning any work. Serious personal injury may
result if safety or operational information is not
understood or followed.
General Condition
1. Electrical connection: Steady state voltage: 0.9-1.1 of
nominal voltage.
Frequency: 0.99-1.01 of nominal frequency continuously;
0.98-1.02 short time
The mains connection must have maximum16A fuse.
Electrical supply which has protection devices of under-
voltage, over-voltage, over-current as well as a residual
current device (RCD) which maximum residual current rated
at 0.03A.
2. Altitude are not exceeding 1000m.
O
Maximum ambient air temperature is +40 C, minimum
O
ambient air temperature is not less than +5 C.
O
Storage and transportation temperature range is -25 C
～
O
+55 C.
The relative humidity does not exceed 50% at a maximum
O
temperature of +40 C, higher relative humidity may be
O
permitted at lower temperature (e.g. 90%@ 20 C).
Floor Load
This machine represents a moderately large weight load in a
small footprint. Most commercial shop floors will be adequate
for the weight of the machine. Some floors may require
additional support. Contact an architect or structural engineer if
you have any question about the ability of your floor to handle
the weight.
To ensure sufficient upright stability of the machine it should be
bolted to floor. For this purpose 4 slots are provided in the
machine's bracket of work stand.
Working Clearances
Working clearances can be thought of as the distances between
machines and obstacles that allow safe operation of every
machine without limitation. Consider existing and anticipated
machine needs, size of material to be processed through each
machine, and space for auxiliary stands and/or work tables. Also
consider the relative position of each machine to one another
for efficient material handling. Be sure to allow yourself
sufficient room to safely run your machines in any foreseeable
operation.
3