Installation Manual
ASR1203-OO *** Valve Rough-In
Dimensions of fixtures are approximate and may vary ± 6mm (1/4”). Structure measurements must be verified against the unit to ensure proper fit.
Product images and specifications are for illustrative purposes only, product design may vary.
4
Removing Plastic Covers:
Remove the protective
Protective Cover (1) and (2)
by
rotating the to the left and pulling outwards.
Open the Stops:
Using a screwdriver, completely open the stops to
maximum opening.
Be sure to not over tighten or loosen the stops as it may
cause the stops to break.
(See Figure D1. on the left)
Install Wallboards and Tiles:
After finishing installation of wallboards and tiles, silicone
around valve box. Silicone to create a seal.
Ensure it is silicone where wall and valve box meet.
2A.
2B.
1
2
2A.
2B.
Thermostatic Valve Cover Plate and Handle Installation
HOT
Open
Open
UP
COLD
UP
D1.
CAUTION!
Do not over open when the stops reach
the maximum opening, as it may cause
the stop to malfunction.
Thermostatic Valve Installation
HOT
C
H
Open
Open
UP
COLD
UP
1B.
1C.
1D.
1
7
8
9
10
11
12
2
3
4
6
5
1E.
(1)
(2)
(3)
(4)
(5)
(6)
(7)
(8)
(9)
(10)
(11)
(12)
Thermostatic Mixer Handle
Cap
Handle set Screw
Volume Control Handle
Plastic Washer
Volume Control Escutcheon
Plastic Washer
Cap
Handle Set Screw
Allen Key
Thermo Escutcheon
Trim
X
X
Diagram 1
ATTENTION!
Please check the thickness, making
sure the plastic surface does not go
beyond the tile surface.
ATTENTION!
REMOVE THE CARTRIDGE BEFORE INSTALLATION.
FLUSH THE HOT AND COLD SUPPLY LINES WITHOUT THE
CARTRIDGE AFTER INSTALLATION. (SEE PAGE 9)
Insert the Valve to the Wall:
(EXAMPLE DIAGRAM 1)
Install the valve so that the outside surface of the finished
wall falls between 57.15mm to 69.85mm (2 ¼" to 2 ¾")
from the back of the valve.
Please check the installation to ensure the plastic surface
on the valve does not go beyond the finished tile surface.
Using a level, adjust the two main points to level, then
install the valve.
Connect the Water Pipe:
Attach
HOT (Left)
and
COLD (Right)
water supply lines to
the thermostatic valve.
Attach water supply line from the outlet to desired shower
components.
Water Sealing Test:
Close the stops with a screwdriver by rotating the stop.
Open the main water pipe line to test the waterway
sealing. If the sealing on water line leaks, fix it then move
on to next step.
Trim/Handle Installation Preparation:
Be sure to check you have these parts before you move
on to the next step.
1A.
1B.
1C.
1D.
1E.
