35
No network connection
can be established.
- Check the LAN cable or the WLAN function
- Try to set an IP address at the device
- Activate the DHCP function on the router and make the connection
again at the device
- A firewall is activated on the network — set the respective program
in such a way that access is possible
- Reboot the router
WiFi connection cannot
be established
- Check the availability of WLAN network on the router.
- Place the device closer to the router
- Make sure the password is correct..
Wired connection cannot
be established.
- Check the availability of LAN network on the access point.
- Reconnect or even replace the LAN cable.
No station is found
- Check the network as well as the access point and firewall.
- The station may not be available currently, try it again later or select
another station.
- The link of the station is changed or the station no longer transmits,
ask the provider for information.
- The link of manual added station is not correct, make sure it is correct
and re—enter
Hiss in FM mode
- Check/move the FM antenna
- Move the radio
No stations available /burbling /
intermittent in DAB mode.
- Move the radio.
- Rescan local stations only (high-strength).
- Check the local DAB coverage.
Alarm does not work.
- Switch on the alarm.
- Due to the volume setting, refer to the solutions of „No sound“.
- The source of alarm was set to be station but there is no network connection.
Change the source of alarm or reconfigure the connection.
USB driver or MP3 player
is not detected.
- Check if the USB driver or MP3 player is plugged properly.
- Some USB hard disks need external power supply, make sure it is
connected to the power.
- Not all MP3 players can be read directly on the device — use an USB
drive instead.
NetRemote does not show or con-
nect to CONNECT-150
- Reopen the App.
- If you have several streaming from several devices at the same time, it
may cause crash, reboot CONNECT-150 and/or your device.
All other undetermined
cases.
- CONNECT-150 may process large amount of data after a period of operation,
no matter in which mode, it will cause the system freeze or malfunction.
Reboot CONNECT-150 if necessary.
- The normal function of the product may be disturbed by strong Electro-
Magnetic Interference. If so, simply reset the product to resume normal
operation by following the instruction manual. In case the function could not
resume, please use the product in other location.
- The device may malfunction when used in areas with strong radio interfe-
rence. The device will work properly again once there is no more interfe
rence.
