auna Akkord 10029895, Инструкция по эксплуатации, Страница: 15 / 31

15
Initial Use
efore initial use, make sure the antenna is completely pulled out. Also, make sure the mains current deli -
vered by your houshold outlets corresponds to those indicated in this manual and on the device. Connect
to a houshold mains outlet.
Connect the device to a houshold mains outlet using the supplied AC/DC adaptor or insert 4 pcs. 1.5V
batteries (type R14) into the battery compartment. Make sure the polarity equates the diagram inside the
battery compartment.
Please note: The display has a auto-dimm function. After any button is pressed, the display lights up for a
few seconds before turning dim again.
Power/Standby
Press Standby to power the device on. The radio automatically tunes in the redio station last listened to.
Press Standby again to switch off.
Turn the volume control to adjust the volume.
Initial Station Scan
When your radio is switched on for the first time it will scan all usable stations and store them in alphanu -
merical order. The initial scan will take a few minutes. After the scan, the number of stations found will be
displayed, and the radio will play the first station in the sequence.
Note:
If no stations are found, switch the radio off and move it to a location with a stronger signal. When
you switch the radio back on it will automatically repeat the scan process.
Use the arrow buttons (up/down) to scroll through the list. Press SELECT to tune in the displayed station.
Setting The Clock
Automatic clock setting:
The clock on your radio is automatically set from the time signal broadcast with
DAB radio stations.
Manual clock setting: If DAB reception is not available in your area, you can set the time manually via the
menu as follows
• Press MENU
• Use the arrow buttons to scroll through the menu until <SYSTEM> appears. Press SELECT to enter the
system menu. Enter with SELECT and scroll (using the arrow buttons) until <TIME> is displayed.
• Press SELECT again, to enter the time setting.