AUMA PROFOX PF-M100X, Руководство пользователя

Страница: 24 / 56

7. Commissioning
Commissioning is made in three steps:
1. End position setting
2. Position indicator setting
3. Configuration of further parameters
Besides end position settings, all other settings have already been made in
the factory in compliance with the order.
If correctly ordered, only end position setting is required.
The following table shows the most important parameters and how they can be
configured.
Page AUMA CDT AUMA Assistant
App At the actuator Parameter/desig-
nation Setting Step
page 25, Set end
position CLOSED Yes Yes Yes End position
CLOSED setting Positions End position set-
ting
page 26, Set end
position OPEN Yes Yes Yes End position OPEN
setting
page 27, Position
indicator setting No No Yes Indication end posi-
tion CLOSED Indication for the
end positions Position indicator
setting
No No Yes Indication end posi-
tion OPEN
— Yes Yes No End position
CLOSED Type of seating Configuration of
further parameters
Yes Yes No End position OPEN
Yes Yes No Tripping torque
CLOSE Torque switching
Yes Yes No Tripping torque
OPEN
page 29, Speed
setting Yes Yes No Speed Speeds
— Yes Yes No Type and assign-
ment I/O signals (bin-
ary/analogue)
— Yes Yes No Various paramet-
ers Positioner
Many further parameters can be configured using the AUMA Assistant App or AUMA
CDT. Refer to Manual (Operation & Setting ) PROFOX.
7.1. End position setting (via push buttons)
When setting the end positions, the actuator acts in accordance with the selected
type of seating:
Limit seating
The final position of the end position is set to the exact current position. Once the
final position is reached, the actuator switches off.
Torque seating
The final position of the end position is set to <1 % before the current position. Once
the torque is reached, the actuator switches off.
In case of torque seating: Check factory torque setting!
24
PF-M25X – PF-M100X
Commissioning Parallel