23
CALIBRATION MODE
4.2
In this mode, the following three key parameters can be calibrated:
I.
Limit Calibration
II.
Position Feedback (E2: DAC Output Calibration (“DAC Cal Mode”)
III.
Command signal Input(E1: 4 – 20 mA Calibration (“4-20mA Cal Mode”)
The following options are also available:
1)
Preset Torque
2)
Change Torque Value
To enter into the Calibration Mode follow the below steps:
Step 1:
Keep the selector switch in OFF position
Step 2:
Press Open + Stop keys (together) approximately 6 seconds
Step 3:
Press the STOP key on the display of “Calibration Mode” as shown below.
The below flowchart depicts how to enter into different calibration modes. For clear understanding of
all options of CALIBRATION MODE,
refer to the detailed flowcharts presented in the following
sections.
