12
3.
FRONT PANEL DETAILS
T
his section outlines the front panel details of 3.XMP Actuators. Fig. A shows the picture of
the same. The functions of each of these components are discussed below.
Fig. A: 3.XMP NON INTRUSIVE WITH BLUETOOTH FRONT PANEL
Selector Switch
3.1
There are 3 modes available; LOCAL, OFF & REMOTE. The mode selection can be
done by using the selector switch.
Push Button Switches
3.2
Actuators are made to run in OPEN or CLOSE direction by pressing the respective
push buttons and can be stopped in middle during travel by pressing STOP push button.
These three push buttons are also used for programming and calibrating the actuator.
LCD Screen & LEDS
3.3
The basic LCD view is split into two lines. The first line shows the status details - The
left half shows selector switch position status and the actuator running status alternatively.
The right half of the first line represents Valve Position (VP) in terms of percentage. The
valve position display feature is optional. If required, an appropriate Electronic Position
Transmitter (EPT) must be chosen for this feature. Please contact AUMA India for more
information.
The second line is used to represent only faults. The faults/warnings if any toggle in
the sequence of occurrence. The details are as shown in the Fig. B.
Information regarding the running indication of the actuator (status) and faults are
indicated by the LEDs present on the left side of the LCD screen which is as shown in Fig. B.
LCD SCREEN
PUSH BUTTON SWITCHES
LED FOR STATUS INDICATION
SELECTOR SWITCH
