AUI bp-9000e, Руководство пользователя

Страница: 12 / 80

AUI BP-9000E Owner's Manual
- 6 -
Caution: Don’t move the print head when the printer is power on, or else, it may damage the printer.
Moreover, don’t touch the print head if the printer has just been recently used as the print
head may be hot.
Note: 1. When your print becomes faint, you need to replace the ribbon cartridge. Otherwise, the
print quality will be affected and the print head may be damage.
2. To remove the old ribbon cartridge, first make sure the power is turned off, move the print
head to the left of the printer. Then pull out the ribbon from ribbon guide, hold the ribbon
cartridge handle on both sides and lift it out of the printer forwards. Install a new one as
the above steps.
3. Please use the original ribbon cartridge only. Manufacturer will not honor warranty when
using unauthorized ribbon cartridge.
4. Please turn the ribbon knob direction as the arrow shown.
2.8 Connecting the Computer
Your printer can be configured with parallel interface, USB interface, serial interface or Ethernet
interface, (Please take the specific interface as standard.). Connect the printer to your computer as
described below. As Figure2-9, 2-10, 2-11 and 2-12 shown.
Note: Before connecting the parallel interface or the serial interface, please make sure the
power of the printer is shut down. Must after tighten the cable you may turn on the
power, or it will damage the printer.
2.8.1 Connecting to the Parallel Interface
1. Turn off both the computer and the printer. Plug the parallel cable connector securely into the
printer's parallel interface. Squeeze the wire clips together until they lock in place on both sides of
the connector. As shown in Figure 2-9.
2. Plug the other end of the cable into the computer's parallel interface; then tighten the screws on
both sides of the connector, make sure it is tight to the interface.
2.8.2 Connecting to the Serial Interface
1. Turn off both the computer and the printer. Plug the serial cable connector securely into the
printer's serial interface. Then tighten the screws on both sides of the connector. As shown in
Figure 2-10.
2. Plug the other end of the cable into the computer's serial interface; then tighten the screws on both
sides of the connector, and make sure it is tight to the interface.
Figure 2-9 Connect to the parallel interface
Parallel interface
Parallel cable
Wire clips