Make Calls with normal Telephones and change Settings
Use the Alarm Function
32
Note: For the switching of a relay via an external telephone you need
an analog DTMF telephone, an ISDN telephone with DTMF signali-
zation or a DTMF sender. If you called the PBX via the special tele-
phone number for remote switching and programming, you will hear
the external acknowledge tone (1 second) and will be able to enter a
digit sequence (with the external PIN). Then you hear the external
acknowledge tone again. If you wait too long with the entry of the
code or if you enter a wrong code, you will hear the busy tone, In this
case hang up the receiver and start again at the beginning.
Activate Alarm via internal Telephone
b ##8s *24 R
*
1#
Sub-Admin PIN
identification number
for the alarm contact
activate “once“
(alarm input is not activated after triggering)
or
2#
activated “always“
(alarm input remains activated after triggering)
or
0#
deactivate
(alarm input is not activated)
Activate Alarm via external Telephone
b r
##8s *24 R *
1#
External
tele-
phone
telephone number for
remote switching and
programming
External PIN
Identification number
for the alarm contact
activate “once“
(alarm input is deactivated after triggering)
or
2#
activate “always“ (alarm input remains acti-
vated after triggering)
or
0#
deactivate (alarm input is deactivated)