Auerswald COMfortel 1500, Руководство пользователя

Страница: 15 / 236

Introduction
First Use of the Telephone
15
First Use of the Telephone
COMfortel 2500: If you like to connect the key expansion module COMfortel Xtension30, read
the
chapter Connection and Mounting of the Key Extension COMfortel Xtension30 (COMfor-
tel 2500) on page 17 first.
For commissioning of the system telephone, the Auerswald PBX must be connected to the
230-V mains supply.
To be able to use the here described scope of functions completely, the system telephone
and the PBX need the following firmware versions:
3.3 A or higher (system telephone)
1.5 C or higher (COMmander Business and COMmander Basic.2)
2.0 A or higher (COMpact 5010 VoIP and COMpact 5020 VoIP)
2.0 E or higher (COMpact 2204 USB, COMpact 2206 USB, COMpact 4406 DSL, COMpact
4410 USB and COMmander Basic).
The versions can be reviewed via system telephone (see
chapter View Information on Tele-
phone and PBX on page 185 ). If you have devices with an older version, please update the
corresponding devices.
Connection of the Receiver
Connect the receiver as follows:
1. Insert the plug at the longer
straight end of the spiral cord
into the jack marked with the
on the bottom side of the
telephone and lead the cable
via one of the cable channels to
the outside (
Pic. 1 ).
2. Put the other end of the spiral
cord into the jack of the
receiver.
Connection to the PBX
Connect the telephone to the PBX as follows:
1. Put one plug of the enclosed ISDN cable into the jack marked with on the bottom
side of the telephone and lead the cable via one of the available cable channels to the
outside (
Pic. 2 on page 16 ).
2. Put the other jack of the ISDN cable into an ISDN wall jack connected to the PBX system.
The system telephone can be operated on an internal S
0
port as well as on an U
P0
port
of the PBX. For each U
P0
port only one telephone can be connected (see also manual of
the PBX).
☞
Advice
Pic. 1: Connection of the Receiver