4
4. Under the print head have enough press power to harm your body, please don't put
your hand under the print head.
5. Dust cover is to prevent dust, sundry etc fell to the print head and plastic roller, try
not to tear down it.
6. The print head is precision electronic components, please don't use hand directly
contact with the print head the surface, not use hard tool collision the print head, the print head
surface will not have water droplets.
Ready to print
（一）
Before print the matters needing attention
1.
Indoor humidity should be about in 55%, temperature in 15
℃-
25
℃
, when necessary,
please use the diffuser and install the air conditioning. (The low and high of the indoor
temperature will affect print effects severely).
2
. Before open the machine : (1) Must be connect with ground wire effectively, each root
ground wire must be individually grounding and shouldn't connect with other machines; (2)
The work of the input voltage for 220 V, voltage is too high or too low can cause equipment
didn't work properly and it must use the ac 220 V, 2 KW power regulator.(3) Check the print
head and aluminum heat sink without water surface carefully and after rubber roller is dry then
open machine.
3.
Machines placed in dry ventilated place and make sure the machine work environment
clean sanitation, no dust; when long-term don't use it, please to the machine to dustproof,
moisture-proof measures, don't place liquid on the case.
（二）
Install and use of the software
This device equipped with artcut 2010 authorised version software, apply for the artcut
version: update the date is April 12, 2011.
1. Install the software
Working
“
SETUP.EXE
”
document, click on 'next', choose the installation directory and click'
confirm'.
2. Set software and use
①
Set print page (in A4 for example)
