Audix M70WD, Инструкция по установке и эксплуатации

Страница: 3 / 4

FIGURE 6
Connect the DN4 Dante interface to a
PoE switch (see DN4 guide).
FIGURE 1
Determine the microphone placement,
drill a 2 inch (51mm) hole in the ceiling
tile or mounting surface.
FIGURE 3
For seismic cable installation, wrap the
cable through beam, eyebolt or hanger
and cable stay barrel (see fi gure 4).
Remove M70WD placement screw and
place eyelet over hole and tighten screw.
FIGURE 2
Remove the knurled ring from the
module, insert the module through
the hole and reattach the knurled ring.
Connect RJ45 cable to the M70 module.
FIGURE 4
Cable Stay Operation
FIGURE 5
Connect up to 4 microphones via Cat5 -
7 to the Audix DN4 interface.
INSTALLATION
CABLE RELEASE PIN
CABLE STAY
BARREL
CABLE