Audison LRX6SR, Руководство пользователя

Страница: 2 / 20

22
INTRODUCTION
INTRODUCTION
Audison
thanks you for preferring this product and compliments you on your choice since it was
designed in order to insure outstanding musical and instrumental performances.
Before use instructions, please carefully read the safety norms you have to respect in order to avoid
unpleasant inconveniences and to enjoy this product at best.
Safety precautions
• The vehicle electric system must have 12VDC voltage with negative to ground. Make sure your car has it
in order to avoid any damages to your amplifier and to the car itself.
• Suitably fix the amplifier with the screws given with it; pay utmost attention if you install it into the
driver’s compartment. Use extra fixing systems if you install it inside the bonnet. If the amplifier
detaches itself while you are driving, it can severely damage people and other vehicles.
• Power supply cable must have mechanically resistant and self-extinguishing insulation. Its section has to
comply with what is indicated in this manual. When placing it, avoid to press it against cutting parts or
close to mechanical moving objects. Make sure it is suitably fixed all along its length. Put a clamping
screw between positive and negative cable just close to the amplifier power supply terminal block.
• Put a fuse holder close to the battery positive terminal;connect one end of the power supply cable to it
after connecting its other end to the amplifier. The fuse value mustbe the same as the amplifier built-in
one. In case the cable supplies several amplifiers, the fuse value will have to beequal to the sum of the
values of all other fuses in the system.
• For safer driving, we recommend to adjust volume not to drown external traffic sounds.
• WARNING. When the amplifier works in particularly hard conditions, it can reach 90°C (194°F). Make sure
its temperature is safe before touching it.
Functioning precautions
• Install the amplifier in locations where temperature is between 0°C (32°F) and 55°C (131°F).
• Don’t connect –L and –R power outputs one to the other. If you use an external stereo crossover, make sure
that its negative poles are not connected one to the other.
• When installing speakers and the cables that connect them, make sure that non-insulated parts don’t
touch the car chassis. If they do, the amplifier protection intervenes.
• Listening level calibration is made by adjusting the source volume up to 3/4 of its maximum level; then,
adjust the amplifier levels until you can hear distortions.
Maintenance precautions
• Periodically clean the amplifier avoiding to use aggressive solvents that might damage plastic or painted
parts. Dampen a piece of cloth with water and soap, wring it and clean the amplifier with it. Then,
clean the amplifier by using a piece of cloth dampened with water only; eventually clean it with a dry
piece of cloth.
Man. LRx 6.SR in 4 Lingue 10-02-2004 16:56 Pagina 22