General Installation Approach
1) Before beginning installation, please refer to warning on page 10.
2) Decide upon system configuration and options that will be installed (ie: what components,
VCP, remote headphones, 2
nd
VCP, etc.).
3) Review all manuals to become familiar with electrical requirements and hook ups.
4) Decide upon mounting locations of all components and method of mounting.
5) Prep the vehicle by removing any interior trim necessary to gain access to vehicle power
hook up point as well as all areas where interconnecting wire harnesses will need to be
located. If any access holes need to be cut into the vehicle (headliner, other trim
components, etc.) this should be done now as well. Refer to page 4.
6) Route the wiring harnesses throughout the vehicle as necessary. (Refer to the wiring
diagram on pages 5 and 6 of this manual as well as the wiring instructions for the individual
components and accessory options being installed). Be sure that all wiring is protected from
sharp edges and is routed in such a manner that it will not be pinched when all components
and interior trim are fully installed. Be sure to leave enough slack in the wiring at each
component to allow working room.
7) Remove all A/V system components from their packaging and place them loosely in the
vehicle at their respective locations.
8) Connect all components together (electrically) and verify proper operation of all system
functions. NOTE: This is best done both BEFORE and AFTER all components have been
permanently mounted.
9) After verifying proper operation of the system, proceed with mounting of each component.
10) When all components are mounted, recheck function of entire system again to ensure that no
wiring was pinched or connected improperly during final installation.
Notes
-
Connecting to both the Wireless Headphones IR Transmitter and a FM Modulator will require
an additional RCA Adapter (P/N 0892165).
-
One dual RCA Patch Cord is needed to connect the TV/Monitor to the Wireless Headphone
IR Transmitter.
-
One dual RCA Patch Cord is needed to connect the TV/Monitor to the FM Modulator, and is
included in the FM Modulator package (P/N 1070610).
-
For audio output, there are a few scenarios that may apply to your system:
a) Remote headphone jacks may be added and located throughout the vehicle.
b) Additional speakers and amplifiers may be added throughout the vehicle.
5
