Troubleshooting
(continued)
In the following cases
Cause
Solution
Used up battery.
(Red indicator for battery
replacement is lit).
Replace with all new batteries
Telescope antenna not
adjusted correctly.
Adjust its length and direction.
Channel not selected
properly.
Select channels by pressing the
selection buttons, and shorten
length of the telescope antenna.
Move it to a location with good
receiving environment.
Poor receiving environment.
Too strong waves
Select channels by pressing the
selection buttons, and shorten
length of the telescope antenna.
Picture not clear
Rolling
Overlapping
Spot or ripple
Reflected waves from the
receiving hill or building.
Select channels by pressing the
selection buttons, and shorten
length of the telescope antenna.
Min. volume.
Rotate volume button to adjust it to
a proper volume.
Earphone, etc. connected to
the earphone terminal.
Pull out what is connected to the
earphone terminal.
Although there are pictures,
no audio signal from the
loudspeaker.
Too strong waves.
Select channels by pressing the
selection buttons, and shorten
length of the telescope antenna.
Min. volume.
Rotate volume button to adjust it to
a proper volume.
There are pictures, but no
sound from the earphone. Earphone connected to
other terminals than the
earphone terminal.
Connect it to the earphone correctly.
Used up batteries.
(Red indicator for battery
replacement is lit).
Replace all with new batteries of the
same variety.
。
All pictures are dim.
TV set body and batteries
are too cold.
Press the switch after leaving the
set at locations with temperature
above 32ºF
Used up batteries.
(Red indicator for battery
replacement is lit).
Replace all with new batteries of the
same variety.
。
Frequency indicator panel
keeps searching.
Poor receiving environment.
Move the set to a location with good
receiving environment.