Audiovox PurSuit PRO9056C, Руководство по установке, Страница: 9 / 24

128-8791b
9 of 24
9
8 Brown Wire: Positive Inhibit Input 1
Any time + 12 Volts is applied to the Brown wire, the Remote Starter will stop operating, even if the signal is
received from the transmitter.
If the vehicle has a factory installed hood pin switch and that switch pr 12 Volts to an under hood light,
the Brown wire can be connected to the existing pin switch.
9 Brown w/ Black Wire: Positive Inhibit Input Plus Trigger When Armed
The Brown w/ Black Trace wire provides an instant shutdown for the Remote Start Control module whenever
it gets + 12 volts also triggers the alarm when armed. If the Brake lights switch in the vehicle sw 12
volts to the brake light circuit, connect the Brown w/ Black trace wire to the output side of the brake switch.
This will allow the Remote Start to shut down if an attempt is made to operate the vehicle without the key
while running under the control of the Remote Start. In most vehicles, in order to shift into gear, the brake
pedal must be depressed. The brake input will in turn cause the remote start unit to shut off.
10 No Connection
11 White Wire: Parking Light Flasher Output
This wire is the normally open contact of the on board parking light flash relay. Connect this wire to the
vehicle's parking light feed wire. This is the wire that gets switched on, either (+) or (-), when the vehicle's
parking light switch is activated.
12 White Wire: Parking Light Flasher Input
This wire is the common contact of the on board parking light flasher relay. If the vehicle you are working on
has +12 volt switched parking lights, connect this wire to a fused +12 volt source. (Max. 15 Amps)
NOTE: If the vehicle's parking lights are ground switched, connect this wire to chassis ground.