background image

128-8190

3 of 8

Page 3

;

 Red dash mounted LED begins to flash slowly.

;

 Parking Lights flash one time.

;

 Siren sounds one chirp

If the siren did not sound when arming, then the chirps have

been turned off and you should refer to the section titled
“ELIMINATING THE ARM / DISARM CHIRPS “ in this manual.

†

 Doors Lock - Optional

Door locking during passive arming is a selectable feature. The
alarm can be programmed to allow the doors to lock only when
arming using the keychain transmitter, and they will not
automatically lock during passive arming.

PROTECTION WHILE THE SYSTEM IS ARMED

;

 Opening any protected door, hood, or trunk lid will cause the alarm to

immediately sound. The alarm will continue to sound for 30 seconds, then stop
and continue to monitor all protected entry points. If the thief left a door opened,
the alarm will sound for six 30 second cycles, remain armed and ignore that
triggered zone.

;

 Whenever the system is armed, the red dash mounted LED indicator will slowly

flash. This serves as a visual deterrent to the potential thief. The LED is a very
low current bulb, and will not cause the vehicle’s battery to drain, even when
left unattended for extended periods.

;

 Whenever the system is triggered, the vehicle’s parking lights will flash for the

full 30 second alarm cycle, attracting visual attention to the vehicle.

†

 Optional - Whenever the system is armed, the vehicle’s starting circuit will be

bypassed. If the thief should choose to ignore the siren, the vehicle can not be
started.

;

 Any mild impact to the vehicle’s glass will cause the alarm to sound a short

series of warning tones.

;

 Any strong impact to the vehicle’s glass will cause the alarm to trigger for the full

30 second alarm cycle.

DISARMING THE SYSTEM

1. As you approach the vehicle, press and release the Unlock button on the keychain transmit-

ter.

;

 Red dash mounted LED turns off.

If passive arming was selected during the installation, then the LED will start
flashing rapidly, indicating that the system is re-arming automatically. Open any
door to suspend the automatic arming.

;

 Parking Lights flash two times.

If the parking lights flashed three times, then the alarm was triggered in your
absence. Before turning the key on, examine the LED to identify which zone
was triggered.

;

 Siren sounds two chirps.

If the siren sounds 4 chirps, then the alarm was triggered in your absence.
Before turning the key on, examine the LED and refer to the INTRUSION
WARNING SIGNALS section of this manual to identify which zone was trig-
gered.
If the siren did not sound when disarming, then the chirps have been turned
off, and you should refer to the section titled " ELIMINATING THE ARM /
DISARM CHIRPS " in this manual.

†

 Doors Unlock - Optional

Note:

If the optional 2 step door unlock circuit is installed, when the unlock transmitter
button is activated, the drivers door only will unlock, pressing the unlock button a
second time will cause all doors to unlock.  If your transmitter has a sperate lock

Содержание Pursuit PRO-9649b









Отзывы: