Page 4
VALET/PROGRAM/MANUAL OVERRIDE SWITCH
(continued)
3. Within 10 seconds of step 2, flip the valet switch to the "on" position.
The dash mounted LED will turn on solid indicating that the valet mode has successfully
been entered.
To return to the normal, (alarm mode), operation, move the valet switch to the "off" position
any time the ignition switch is in the on position.
Note:
In the event that you lose your keychain transmitter or the transmitter fails to oper-
ate the alarm system, the valet switch can be used to disarm the alarm. This is referred to
as the "Manual Override". To disarm the alarm:
1. Open the door with the vehicle door key. (The siren will sound)
2. Turn the ignition switch to the "on" position.
3. Flip the valet/override switch to the "on" position.
The system will disarm and the siren will stop sounding, allowing the engine to be started,
and the vehicle to be operated normally. Always remember to move the valet switch back
to the "off" position to allow the passive arming and optional starter interrupt features to be
operable the next time you park the vehicle.
INTRUSION WARNING SIGNAL
This system will inform you if an intrusion attempt has occurred while you were away from
the vehicle. Upon disarm, the siren will chirp 4 times and the parking lights will flash 3
times. Enter the vehicle and
before
turning on the ignition switch, observe the LED flash
pattern.
If the LED flashes two times...pause, two times...pause etc., then an intrusion attempt was
made to open the hood or trunk, or an impact or a strong vibration was applied that the
optional shock sensor detected. Check the vehicle for indications of forced entry to these
openings, or signs of glass breakage or body damage.
If the LED flashes three times...pause, three times...pause etc., then an intrusion attempt
was made to the vehicle doors. Check all doors for indications of forced entry.
Note:
The LED intrusion warning indications are stored in the system's memory and will
be erased when the ignition switch is turned on.
ELIMINATING THE ARM/DISARM CHIRPS
You can selectively eliminate the normal arm & disarm chirps by holding the transmitter
button slightly longer when arming and disarming. This will prevent the siren chirps for
one arm or disarm cycle. If you find this inconvenient and wish to eliminate these chirps
permanently,
1. Start with the valet switch in the "off" position.
2. Turn the ignition switch "on" then "off".
3. Within 10 seconds of turning off the ignition, flip the valet switch "on", "off", "on", "off",
"on", "off".
4. If the chirps were on before you started, the siren will emit 2 short chirps indicating that
the chirps are now off. If the chirps were off before you started, the siren will emit one
short chirp indicating that the chirps are now on.
