6
If you desire to have the transmitters operate differently from this factory configuration, please refer to the separate Trans-
mitter Programming Guide that came with the APS-45 system.
PROGRAMMING FEATURES:
There are seven (7) Programmable Features on the APS-45 system. Study the list below, keeping in mind the features and
their defaults, (how it comes programmed from the factory), and decide how best to program the APS-45 for your particular
installation.
Programmable Features:
Features
1 Chirp
2 Chirp
3 Chirps
Default
First
Passive Arming
Active Arming
Active Arming
Second
Ignition D/L ON
Ignition D/L OFF
Ignition D/L OFF
Third
Ignition D/UL ON
Ignition D/UL OFF
Ignition D/UL OFF
Fourth
Chirps ON
Chirps OFF
Chirps ON
Fifth
Passive D/L
Active D/L
Active D/L
Sixth
Siren Output
Horn Output
Horn Output
Seventh
800ms D/L Pulse
3.5 Sec. D/L Pulse
800ms D/L Pulse
800ms Door Lock
Double 800ms D/UL Pulses
To Program These Features:
Entering the Programming Mode involves operating the Ignition Switch and the Valet/Program/Manual Override Switch in a
particular sequence. This sequence is very time dependent, in other words it must be performed quickly in order for you to
enter the mode. This sequence is also only one step different from the Transmitter Programming Mode, so make certain
you perform the sequence properly.
Upon entering the Programming Mode, the system is immediately set to allow adjustment of the First Programmable
Feature. That First feature, "Passive or Active Arming", can then be set ON or OFF by pressing button 1 of the transmitter.
The system confirms that it is set to adjust the First feature by repeatedly flashing the LED once, with a pause in between
each flash. The system will then report how the feature has been set by the number of chirps heard after pressing the
transmitter button. Toggling the Valet/Program/Manual Override Switch once again will advance you to the Second
Programmable Feature, confirmed by a repeating two LED flashes, with a pause in between each flash, etc., etc.
It is important to note that when you first enter the Programming Mode, you are automatically positioned to adjust the First
Programmable Feature, and that the Valet/Program/Manual Override Switch allows you to toggle from there through each
of the six more programmable features. However, it will not allow you to return to any feature once you have toggled past
it. Should you accidentally toggle past the feature you wanted to program, you must exit and re-enter the Programming
Mode and then adjust the feature you missed.
It is also important to note that you may toggle past as many programmable features as you wish without having to adjust
them. Each time you toggle forward to a new feature, the horn will chirp the appropriate number of times (1, 2, or 3 times)
to indicate how that feature is currently set, and the LED will flash the appropriate number of times to indicate the number
of the feature (First through Seventh) that you are set to adjust. For example, you might enter the mode and toggle the
Valet/Program/Manual Override Switch 3 times in order to adjust the Fourth programmable feature. The system would
respond with 1 Chirp, and the LED would begin to flash 4 Flashes, pause, and repeat. This has told you that the system is
ready for you to adjust the Fourth programmable feature, and that it is currently programmed for Chirps ON. A single press
of button 1 of the transmitter will cause the system to produce 2 Chirps. This signifies that you have changed the
programming to Chirps OFF. Please follow the programming procedure on the next page, and refer to the list of the
Programmable Features above when programming the APS-45.
