Page 3
DISARMING THE SYSTEM (CHANNEL 1):
1. As you approach the vehicle, press and release the button on the key chain transmitter.
WARNING! Excessive pressure on the transmitter buttons will damage the internal
components on the circuit board. All that is required is a light push to the button.
2. The siren will “chirp” 2 times and the vehicle's parking lamps will flash two times.
a) If the door lock interface (optional) is installed, the vehicle’s doors will automatically
unlock.
3A. ACTIVE: The dash mounted LED will turn off, and remain off until the system is armed.
3B. PASSIVE : Never attempt to disarm the system from a distance that prevents you from
opening a door within 30 seconds. Since the system is programmed for passive arming,
it will begin to re-arm until a door is opened. Opening the door will suspend the passive
arming cycle.
INTRUSION WARNING SIGNALS:
The system will inform you if an intrusion attempt has occurred while you were away from
the vehicle. If an intrusion attempt has occurred, the siren will “chirp” 4 times when disarming
the system. Enter the vehicle and observe the dash mounted LED for further information.
1. If the LED is flashing one time...pause... one time...etc., then an intrusion attempt was
made to a light activated entry point, or the plug in shock sensor was activated.
2. If the LED is flashing two times...pause...two times...etc., then an intrusion attempt
was made to the hood, trunk, or any optional sensors that were added to the vehicle.
3. If the LED is flashing three times...pause...three times...etc., then an intrusion attempt
was made through one of the vehicles doors.
These intrusion warning indicators are stored in the system’s memory, and will only be erased
from memory when the ignition key is turned on.
VALET / SYSTEM OVERRIDE SWITCH:
The “Valet” switch allows you to temporarily bypass all alarm functions, eliminating the need
to hand your transmitter to parking attendants or garage mechanics. When the system is in
the valet mode, all alarm functions are bypassed, however, the remote panic feature and
remote door locks (optional) will remain operational. To use the valet mode;
1. Enter the vehicle and turn the ignition key to the “on” position.
2. Move the valet toggle switch to the “on” position. The dash mounted LED will turn on solid,
and remain on as long as the system is in the valet mode.
3. To return to normal operation, move the valet switch to the “off” position any time the ignition
is on.
In the event you lose your transmitter, or if the transmitter fails to disarm the system, the valet
switch can be used as a system override switch. Open the car door (the alarm WILL sound).
Turn the ignition key on, and move the valet switch to the “on” position. The alarm will stop
sounding, and the vehicle can now be started.
NOTE: Always remember to move the Valet Switch back to the ”off” position. This will ensure
that the vehicle remains protected at all times.
