128-6690
4 of 8
2 Enter the transmitter program mode. Using any transmitter button press
and hold until a long chirp is heard. If a single chirp or multiple chirps, (up to
7 chirps), are heard, the unit is indicating that the transmitter has already
been programmed elsewhere in the receiver. Release the transmitter button
and within 5 seconds press and hold until a long chirp is heard. This action
forces the unit to erase all stored codes of that transmitter.
The unit then exits the program mode the siren emits the program mode exit
chirp pattern. All transmitter buttons for that transmitter must now be repro-
grammed. Any other transmitter stored in the unit’s memory still remain
operational. If the button is released and not pressed again within the 5
second period, no change in programming has been made to the receiver
channel. The programmer can move onto a different channel or erase the
transmitter codes as described in 1 above.
REPLACING THE BATTERY:
You will notice a decrease in transmitter range as the battery condition
deteriorates.
The low battery indicator shown left, also the top LED on the transmitter
will light Green when any button is pressed indicating that the battery condition
is good. If the LED Lights Red when any transmitter button is pressed, this is
a indication that the battery is low and needs to be replaced. Transmitter battery
replacement is recommended at least every 6 to 8 months, depending upon
how frequently the transmitter is used.
To replace the transmitter battery:
1. Slide back the lock tab on the back side of the transmitter case in the direction
shown.
2. Slide back the battery case cover in the direction shown.
4