128-8601
6 of 8
DELETING TRANSMITTERS FROM YOUR SYSTEM:
It may be necessary to delete a lost transmitter or to reprioritize a transmitter that is
programmed to your system. To remove a transmitter that has been programmed in your
system:
1) Enter the transmitter program mode of channel 1 as indicated above.
2) Press and hold any transmitter button that has not been programmed into channel 1
until you hear a chirp, then release and immediately press the same button a second time
until you hear a long chirp followed by a short chirp. This action erases the transmitter.
If the transmitter you wish to erase has been lost or stolen then following the information
below will successfully remove the transmitter.
NOTE:
For this procedure, you must have all transmitters you wish to remain pro-
grammed in your system available.
1) Enter the transmitter program mode of channel 1 as indicated above.
2) Press and hold the lock button of each transmitter you wish to operate the lock
function of your unit making sure you occupy all 4 transmitter slots. In other words, you
have three transmitters you wish to remain programmed. Press and hold the lock button
of transmitter one until a long chirp is heard, then press and hold the lock button of
transmitter two, then press and hold the lock button of transmitter three, followed by
pressing and holding the lock button of transmitter one again. This action fills all 4
receiver slots.
3) Advance to receiver channel 2 by pressing the push-button switch one time.
4) Press and hold the unlock button of each transmitter you wish to operate the unlock
function of your vehicle, again making sure all 4 transmitter slots are filled.
4) Advance to receiver channel 3 by pressing the push-button switch one time.
5) Press and hold the unlock button of each transmitter you wish to operate the start
function of your vehicle, again making sure all 4 transmitter slots are filled.
If you are uncomfortable about the programming of additional transmitters as outlined in
the processes above please contact your installation center or call the technical service
number listed on the back of the transmitter for help.
BATTERY REPLACEMENT
The transmitter incorporates a small LED visible through the
case which is used to indicate battery condition. You will
notice a decrease in transmitter range as the battery con-
dition deteriorates. Transmitter battery replacement is
recommended at least every 10 to 12 months, depending
upon how frequently the transmitter is used.
To replace the battery in the 91P Transmitter
1) Carefully pry apart the case using the edge of a coin as shown.
2) Remove the rear cover to access the discharged battery paying attention to the proper
polarity orientation.
3) Carefully remove and properly dispose of the discharged battery.
4) Insert the new battery, than carefully snap closed the transmitter case.
5) If you accidently dislodge the circuit board from the transmitter housing, be certain that
the rubber membrane is seated properly, and the buttons are properly exposed from the
front view of the case, then insert the circuit board, and return to step #4.
91P Uses 2 x CR2016 Lithium Battery
