128-6538
3 of 10
Page 3
ARMING THE SYSTEM - PASSIVE ( AUTOMATIC )
1. Turn off the engine, exit the vehicle, close and lock all doors, hood lid and trunk lid.
þ
Red dash mounted LED begins to flash rapidly, indicating 30 second passive
arming has begun.
2. Opening any protected entry point during the 30 second passive arming cycle will imme-
diately suspend automatic arming, and the 30 second passive arming cycle will restart
when all doors are closed. At the end of the passive arming cycle;
þ
Red dash mounted LED begins to flash slowly.
þ
Parking Lights flash one time.
þ
Siren sounds one chirp
If the siren did not sound when arming, then the chirps have
been turned off and you should refer to the section titled
“ELIMINATING THE ARM / DISARM CHIRPS “ in this manual.
o
Doors Lock - Optional
Door locking during passive arming is a selectable feature. The
alarm can be programmed to allow the doors to lock only when
arming using the keychain transmitter, and they will not
automatically lock during passive arming.
PROTECTION WHILE THE SYSTEM IS ARMED
þ
Opening any protected door, hood, or trunk lid will cause the alarm to
immediately sound. The alarm will continue to sound for 30 seconds, then stop
and continue to monitor all protected entry points. If the thief left a door opened,
the alarm will sound for six 30 second cycles, remain armed and ignore that
triggered zone.
þ
Whenever the system is armed, the red dash mounted LED indicator will slowly
flash. This serves as a visual deterrent to the potential thief. The LED is a very
low current bulb, and will not cause the vehicle’s battery to drain, even when
left unattended for extended periods.
þ
Whenever the system is triggered, the vehicle’s parking lights will flash for the
full 30 second alarm cycle, attracting visual attention to the vehicle.
o
Optional - Whenever the system is armed, the vehicle’s starting circuit will be
bypassed. If the thief should choose to ignore the siren, the vehicle can not be
started.
þ
Any mild impact to the vehicle’s glass will cause the alarm to sound a short
series of warning tones.
þ
Any strong impact to the vehicle’s glass will cause the alarm to trigger for the
full 30 second alarm cycle.
DISARMING THE SYSTEM
1. As you approach the vehicle, press and release the Unlock button on the keychain trans-
mitter.
þ
Red dash mounted LED turns off.
If passive arming was selected during the installation, then the LED will start
flashing rapidly, indicating that the system is re-arming automatically. Open
any door to suspend the automatic arming.
