11
VOD128A
1)
Make the connections to the vehicle for the 12 pin wiring harness.
2)
Connect power harness to vehicle’s electrical system by tapping into an accessory hot
line and a good ground.
3)
Connect the 12 pin harness to the mating connector on the Video Monitor.
4)
If an auxiliary video input is used (VCP, DVD, etc) insert the Circular Mini-Din
Connector of the source component harness through the wire tie loop on the main
PCB and into the Mini-Din Connector on the main PCB.
5)
Pull the wire tie loop tight and cut off the excess.
Note:
A VCP or other A/V Component can be connected to the video monitor system
using a source component harness (purchased separately, part number: 8010730).
This harness plugs into the Mini-Din connector on the main PCB as in steps 4 and 5
above.(See Figure A on next page)
6)
Verify all functions of the System before final mounting of the finished assembly.
A/V Source Definitions:
1. DVD – Built in DVD
2. VIDEO 1 (DIN 1)
3. VIDEO 2 – Supplied 9 Pin to 3 RCA Jack Pigtail is used for VIDEO 2 input.
4. VIDEO 3 – AUX/Game/IPOD
*NOTE:
If the optional relay box P/N SIRSWB is installed, it recommended that the
antenna for the wireless FM Modulator be unplugged. See VOD128A Wiring
Diagram (Figure A) for antenna location.
**NOTE:
Extending the wireless antenna beyond its 12 inch length will cause the FM
Modulator to exceed FCC limits for wireless transmission. When installing the
unit position the antenna for best reception.
