INSTALLATION INSTRUCTIONS
1. Select a mounting area where the crossover
will be accessible for occasional adjustment of
control settings.
2. Place the crossover on the mounting surface
and mark the locations of the four mounting
holes as shown in the illustration.
3. Remove the crossover and drill a 1/8" hole at
each of the four locations.
CAUTION:
Before drilling the holes, look at the
underside of the mounting surface. Always
check carefully to avoid drilling into wiring,
braces, fuel or brake lines.
CHECK BEFORE
YOU DRILL !
4. Secure the crossover to the mounting surface
using the self-tapping screws and washers
provided.
-2-
MOUNTING SURFACE
SELF-TAPPING SCREW
FLAT WASHER
INSTALLATION DIAGRAM
1/8" DIA.
HOLE
30Hz
30Hz
