memory without annoying key tones over the circuit.
1. Press
then key
q
then enter a phone
number. (Tone/ will be displayed for 5 seconds.
The Microphone circuit will remain active, but
the tones will not be heard.
2. If necessary, press
then enter the memory
address.
3. To exit the Scratch-pad Mode, press
key
again or turn the unit off.
DATATRANSMISSION
AUX I/O JACK on the phone cradle can be used for
a FAX machine, Modem or other Data Transmitting
equipment. Specifications of AUX I/O JACK are as
follows.
JACK
Impedance
600 ohms, Balance
Level
Input nominal 17dBV
Output nominal -32dBV
Manual Mode
To set Data Transmission Mode
After a call is in progress (answered or sent), press
t h e n
w i l l a p p e a r o n t h e
readout. Then the transmission and receiving audio
will be switched to the AUX I/O JACK.
To Exit Data Transmission Mode
Press
then
or terminate a call.
The indication
on the readout will go out.
Automatic Mode
1.
Before leaving the car, press
then key
q
(more than 1 second). The display shows
The unit will remain power-on even after the igni-
tion switch is turned off. If necessary, lock the unit.
2. When a call is received, the unit will automatically
make the connection, then the transmit and
receive audio will be switched to the AUX I/O
JACK.
3. This mode is automatically deactivated in the
following cases:
1) When the ignition switch is turned back to
“on” or “accessory” position.
2) When the safety timer is expired. (Refer to
“Safety Timer”.)
3) When
then key
q
are pressed again.
4) When Calls in Absence Indicator feature is
activated.
CALLTIMEDISPLAY
This feature automatically records the elapsed time
per conversation. The talk time of the last call,
cumulative talk time, and the number of calls can be
displayed on the readout.
The timers can also be cleared if necessary.
With beep tones you can be notified of the approxi-
mate talk time (NAM Option) in approximately 60
second increments.
To Display the Talk Time of the Last Call
1.
Press
key
then
The talk time of the last call will be displayed on
the readout for 5 seconds.
While in a conversation, the talk time of a call in
progress will be displayed, and updated each sec-
ond. The display format is as follows.
min. and 25 sec.
To Display the Cumulative Talk Time
1.
Press
key
then
q
The cumulative talk time will be displayed on the
readout in minute format for 5 seconds.
.
To Display the Number of Calls
1. Press
key
then
q
The number of calls will be displayed on the
readout for 5 seconds. The display format is as
follows.
.
or placed 86 calls
To Clear the Timer
1.
Press
then enter the three-digit security
code.
2. Press
key
q
then
The timers will be cleared, and the count for the
cumulative talk time and the number of calls will
start from zero.
One Minute Beep (NAM Option)
During conversation, you can be notified of the
approximate talk time by tones for the first five
minutes. (A short monotone signal will sound every
minute and a double beep tone will be heard after
approximately 5 minutes.)
Содержание CTX3200
Страница 1: ......
