Audiovox Advent PSD100, Руководство по установке, Страница: 9 / 17

8
Installing the Power Harness (REAR)
1. REAR SENSORS - POWER HARNESS INSTALL.
For installation in the REAR of the vehicle, locate a source of reverse power
(usually at taillight assembly) and accessory power (usually cigarette lighter).
a) REVERSE POWER
Using the tap connector supplied, perform the following steps:
i. Place the un-stripped positive reverse power lead wire on the
run channel.
ii. Insert the un-stripped RED power wire completely.
iii. Make the connection between the wires by crimping down the
metal connector with a pair of pliers, making sure the metal is
flush with the plastic insulator.
iv. Close the top hinged cover until latched.
b) GROUND
The ground wire should be secured directly to the vehicle body or
to a ground wire directly attached to the vehicle body. Using the tap
connector supplied, perform the following steps:
i. Place the un-stripped ground (earth) lead wire on the run
channel.
ii. Insert the un-stripped BLACK power wire completely.
iii. Make the connection between the wires by crimping down the
metal connector with a pair of pliers, making sure the metal is
flush with the plastic insulator.
iv. Close the top hinged cover until latched.
c) ACCESSORY POWER
i. Place the un-stripped accessory lead wire on the
run channel.
ii. Insert the un-stripped ORANGE ground wire completely.
iii. Make the connection between the wires by crimping down the
metal connector with a pair of pliers, making sure the metal is
flush with the plastic insulator.
iv. Close the top hinged cover until latched.
2. Route the power harness wires with the sensor wires to the control box.
Tap/Run Connection