cq
DISC EJECT ( )
Disc play is stopped, the disc is ejected and
the unit will change to radio operation by
pressing this button (“EJT” will briefly appear
on the display panel). If the disc is not re-
moved from the unit and the button is pressed
again, the disc will be re-loaded and begin
playing.
cr
TIME/FREQUENCY DISPLAY SELECTOR
(T/F)
Press this button to call the time display on
the incorporated quartz clock. Press the
button again to return to radio frequency or
disc display or it will return automatically af-
ter 5 seconds.
cs
THEFT-DETERRENT LED
Located on the chassis behind the front
panel, a light-emitting diode (LED) will flash
when the panel is removed. The flashing
light serves as a visual warning to the would-
be thief that the unit has been disabled by
removal of the front panel.
ct
RE-SET BUTTON
A Re-Set button is located on the front of the
chassis (front panel must be removed to ac-
cess the button). The re-set circuitry is pro-
vided to protect the microprocessor cir-
cuitry and should only be activated un-
der the following circumstances.
1. Upon initial installation after all wiring is
completed.
2. If there is a malfunction of any of the
switches on the unit or of the CD player,
pressing the Re-Set button may clear
the system and return to normal
operation.
9
9
9
9
9
OPEROPEROPEROPEROPER
AAAAA
TTTTT
ING INSTRUCING INSTRUCING INSTRUCING INSTRUCING INSTRUC
TTTTT
IONSIONSIONSIONSIONS
cu
FRONT PANEL RELEASE BUTTON (
)
This button is used to release the mechanism
that holds the front panel to the chassis. To de-
tach the front panel, press the button so that the
left side of the panel is released. Grasp the re-
leased side and pull it off of the chassis. To re-
attach the panel, position the right side of the panel
in place first and then press the left side of the
panel until the mechanism locks it into place.
NOTES ON USE OF FRONT PANEL
1. Make sure the front panel is right-side-
up when attaching it to the chassis as it
cannot be attached when up-side down.
2. Do not press very hard on the front panel
when attaching it to the chassis. No
more than light to moderate pressure
should be needed.
3. When attaching the front panel, make
sure the right side is correctly engaged
before pressing the left side to lock it into
position.
4. When taking the front panel with you,
please use the supplied carrying case to
protect the panel from dirt and damage.
