Audiovox ACAB104, Руководство по установке

Страница: 8 / 14

7
Installing the Sensor Sleeve and Sensors
NOTE : When installing the sensors into the sensor sleeves, push on the outer
ring of the sensor only. Never push on the center of the sensor..
1. Press the pre-selected sleeve into a 28mm hole in the bumper, making sure
the thinner edge of the sensor sleeve is at the top of the hole.
2. Run the sensor wires through the sensor sleeves in the bumper.
3. Press on the outer ring of the sensor and push until the sensor is flush with the
sensor sleeve. The sensor should fit snugly into the bumper and lock into
place.
4. Determine where the sensor wires will enter into the trunk area or passenger
compartment. Many vehicles have a factory grommet to allow routing of
wires from the outside to the inside of the vehicle. If needed, drill a hole to
route the wires into the vehicle, taking care when drilling metal. Smooth
edges with a round metal file and use a rubber grommet to protect the wires.
5. Feed the sensor wires through the factory grommet or other opening into the
vehicle for connection to the control module (e.g., into the cab of most trucks
or the trunk of passenger cars).
NOTE:
Once the wires are passed through, make sure there is enough
wire to route to the control module. Check that the sensor wires
will not be pinched by moving parts or panels.
6. Cable tie the sensor wires and the power harness wires behind the bumper,
keeping them away from the exhaust system or moving suspension parts
( install power harness before using cable ties ). Do not pull on the sensor
wires near the sensor shaft exit point, as this may damage the inner
connections.