Warning:
FCC Compliance
This equipment has been tested and found to comply with the limits for a digital
device, pursuant to part 90 of the FCC Rules. These limits are designed to provide
reasonable protection against harmful interference in a residential installation. This
equipment generates, uses and can radiate radio frequency energy and, if not installed and
used in accordance with the instructions, may cause harmful interference to radio
communications. However, there is no guarantee that interference will not occur in a
particular installation. If this equipment does cause harmful interference to radio or
television reception, which can be determined by turning the equipment off and on, the
user is encouraged to try to correct the interference by one or more of the following
measures:
· Reorient or relocate the receiving antenna.
· Increase the separation between the equipment and receiver.
· Connect the equipment into an outlet on a circuit different from that to which the
receiver is connected.
· Consult the dealer or an experienced radio/TV technician for help.
Modifications not authorized by the manufacturer may void users authority to operate this
device.
FCC Licensing Requirements
Your radio must be properly licensed Federal Communications Commission prior to use.
Your dealer can assist you in meeting these requirements. Your dealer will program each
radio with your authorized frequencies, signaling codes, etc., and will be there to meet
your
communications needs as your system expands.
Safety:
It is important that the operator is aware of and understands hazards common to the
operation of any radio.
READ THIS IMPORTANT INFORMATION ON SAFE AND EFFICIENT
OPERATION.
The EUT is Face-held only, not allow to body-worn configuration, the safety distance
should be at least 2.5 cm.
