8
6.
Use the included hardware to secure the camera in place. DO NOT OVERTIGHTEN
the hardware.
7.
Wire the Camera’s power wire to the vehicle’s reverse lamp.
a)
Locate the reverse lamp in the tail light assembly.
b)
Using a crimp connector or by soldering attach the red wire to the positive 12
volt wire from the reverse lamp. This should only have power when the car is in
reverse gear and the white lamp it illuminated.
Attach the black wire to the ground (Negative 12 Volts only).
c)
If a trigger wire is required at the front of the vehicle or you wish to power your
camera from the front of the vehicle use the additional red wire on the video
extension cable. NOTE: Do not connect to the reverse lamp and to power at the
front of the vehicle. This will cause the reverse lamp to turn on any time you
power the camera.
