TECHNOLOGY
10 WATT / 70 VOLT STEREO VOLUME CONTROL
SPECIFICATIONS
INSTALLATION
WARRANTY
Attenuator type:
Tapped auto transformer.
Switch:
12 position rotary, make-before-break contacts,
low torque specifications for smooth feel.
Connectors:
Screw type, non-removable.
Power Input Rating:
10 Watts RMS continuous. 35 Hz-20 KHz.
Attenuation:
34 dB in 12 steps: 8 steps @ -3 dB, 1 step @ -4 dB, 1 step @ -6 dB, last
step OFF.
Transformers:
Grain-oriented, high silicon steel laminations.
Mounting:
Fits most standard single gang electrical junction boxes.
1.
Make connections by stripping wire insulation back about 3/16". twist any loose strands tightly to
avoid short circuits.
2.
Insert the wires from the amplifier into the INPUT openings of the connector, hot to hot and ground
to ground, then tighten screws. Check for stray wires strands that could cause a short circuit. Make
sure that the metal part of the screw connector engages the bare wire, NOT the insulation!
3.
Similarly, connect the speaker wires to the OUTPUT openings on the connectors and tighten the
screws.
4.
Install the control in its operating position. Suggestion: Leave control 3 or 4 positions CCW from
maximum before firing up the system for the first time to avoid "blasting" the speakers, while still
having enough sound to observe operation.
Your AUDIOPLEX TECHNOLOGY Stereo Speaker Volume Control is covered by a LIFETIME
warranty against defects in workmanship and materials. Any defects will be remedied without charge for
labor or parts.
Damage incurred by shipping or by accident is not considered to be a defect, and not covered by this
warranty. AUDIOPLEX TECHNOLOGY is not responsible for defective operation caused by abuse or by
modification or service by any unauthorized person or agency.
The product must be properly installed and operated according to instructions for this warranty to
apply. Any necessary servicing must be done by AUDIOPLEX TECHNOLOGY. The product must be returned
expenses prepaid, with written authorization from the company. The product must be shipped with the proof
of purchase and in the original carton and packing material to avoid damage.
This warranty gives you specific legal rights. You may have other rights which vary from state to
state.
Installation must be made by qualified service personnel, and must meet all local codes.
INSTALLATION MANUAL
1999 - 4/22/99
