COMPACT500 - Amplified system with subwoofer and satellites -500W
Page 6
English
7- Line output mode
Allows you to choose the signal injected to the outputs No. 4.
Left selector: The Line Out output only transmits the CH2 signal.
Right selector: The whole signal is transmitted from the system to the Line Out outputs.
8 - Balance
Allows you to adjust the distribution of the signal on the left and right satellites.
9 - ON/LIMIT signal indicator
Allows you to check on the volumes
(PLEASE MAKE SURE EACH CHANNEL IS CONFIGURED IN ORDER TO PREVENT THIS INDICATOR FROM BEING
LIT)
10 - Subwoofer sound level
The subwoofer volume can be adjusted separately. Use this knob to adjust it as desired. By default, the system is
balanced when this knob is in middle position.
(PLEASE MAKE SURE TO CONFIGURE IT IN ORDER TO PREVENT THE LIMIT FROM BEING LIT)
11
-
Mounting plate
Allows you to insert a 35 mm tube to pole-mount satellites. One of the tubes of the supplied speaker stand can be
used to mount your satellites.
12
-
Channels 1 to 3 DSP
This setting allows you to adjust the sound of each channel to meet your needs. When on the left, the sound is
very neutral and is perfect for vocal uses: basses and trebles are dimmed. In the middle position, the correction
remains neutral and respects the original source, toward the right, mediums are lowered while basses and trebles are
reinforced to produce a more dynamic output.
13 - Channels 1 to 3 input selector
Allows you to choose the type of source connected to each channel.
14 - Channels sound level
Allows you to adjust the sound level of each channel.
This setting also affects the main volume level of the amplification system.
(PLEASE MAKE SURE TO CONFIGURE IT IN ORDER TO PREVENT THE LIMIT FROM BEING LIT)
CAUTION
Please make sure to properly configure the sound levels of your system. In addition to being unpleasant for
the audience, improper settings can damage your whole sound system.
The "LIMIT" indicators will light on when the maximum level is reached and must never be permanently lit.
Beyond this maximul level, the volume will not increase but will be distorted.
Moreover, your system can be destroyed by an excessive sound level despite of the internal electronic protections.
First, in order to prevent that, adjust the sound level via the Level of each channel.
Then, use the DSP to adjust the acoustic as you wish.
Finally, adjust the volume of the subwoofer.
If the sound output does not seem powerful enough, we strongly recommend to multiply the number of systems or
satellites in order to spread the sound output evenly.
