Audionet AMP II G2, Руководство пользователя, Страница: 6 / 12

6
The amplifiers will shut down automatically when no input signal is de-
tected for a user definable time (30 seconds up to 2 hours).
To activate and setup this feature please refer to chapter "Programming".
Due to security concerns the "Auto-On" feature will only be available
after first manual switching on!
While you are absent your AMP II G2 can switch on automatically and
will be pre-heated for use when you get back. To activate this feature
please use a
long key press on the " power " button at the front. The display
changes to show the countdown timer. A cursor will mark the number to
be changed. A
long key press will move the cursor one step to the right.
Using a short key press you can change the desired number. Hours can be
programmed in steps of one hour. Minutes can be programmed in steps of
15 min. The following diagram explains the possible countdown timer
settings:
0 1 hour 15 min 0 1 hour 15 min 01 hour 15 min
1 1 hours 15 min 0 2 hours 15 min 01 hour 30 min
9 1 hours 15 min 0 0 hours 15 min 01 hour 00 min
10-hours-setting 1-hour-setting Min-setting
Legend: long key press short key press
Activate countdown by leaving the timer settings menu with a long key
press. It will be activated automatically if you do not change any setting
for longer than 10 seconds.
If you want to use the countdown timer again it is activated by a single
key press. Press the "
power
" button for more than 2 seconds and wait.
After 10 seconds the previous set up countdown will start again.
To deactive the countdown use a short key press at any time.
"Warm Up" Countdown