AUDIOLINE VR500, Руководство по эксплуатации

Страница: 35 / 40

- Fault finding -
35
9. FAULT FINDING
The display is blank.
-
Switch the unit on by means of the REC button.
-
Check the battery capacity.
-
Check that the polarity of the batteries is correct.
No notes are recorded
-
Check the setting of the HOLD switch.
-
Check whether the maximum memory capacity or the maximum number of notes in an archiv-
ing folder has been exceeded.
-
Check the battery capacity.
No notes are played back
-
Check the setting of the HOLD switch.
-
Check whether there are any recordings in the selected folder.
-
Check the battery capacity.
Recordings cannot be heard.
-
Check the volume setting.
-
If you want to listen to the notes via the inbuilt loudspeaker, then an earpiece or headphones
must not be connected.
-
If you want to listen to the notes via another loudspeaker, then the cable must be connected
correctly.
Display message ERROR
- Carry out a reset
- If you have connected a PC via USB, check the cable connection.
Display message REPAIR
- If the batteries should fail during a recording, the message REPAIR will appear in the display
for a certain time in order to repair the recording.
Reset in the case of a fault
Note:
All recordings will be erased!
-
Remove the battery.
-
Replace the battery and hold the ERASE and REC buttons pressed simultaneously for 7
seconds.
-
The display will show "AL CLEAR".
-
Press the ERASE button again and the reset is complete.