12
Putting the Telephone into Operation
20
Wall installation
The telephone can also be installed on a wall. Use two screws to insert in the holding slots.
Drill two holes 67 mm apart vertically under each other, insert the screws and allow them to
project 5 mm from the wall. The tabletop support is not required for wall installation. Position
the slots in the telephone base over the screws, insert and slide the telephone down a little.
Caution:
Ensure there are no cables or pipes in the wall where the hole is drilled.
In order that the receiver does not fall when placed on−hook, there is a small receiver clip in
the receiver cradle. Use a small screwdriver to turn the clip 180° until a small hook is created
at the top end. You can then place the receiver on−hook.
If the handsfree" function is not activated, you can hook the receiver on the telephone
without interrupting the connection. To do this, there is a hook provided above the
receiver cradle.
Basic settings
When the batteries have been inserted, you are requested to program some basic settings. In-
formation on the methods of illustration and notation used in the operating manual is available
on Page 22.
Setting the language
y
or
z
e.g.:
[
ENGLISH
]
,
C
Select the language and confirm
Setting the contrast
y
or
z
e.g.:
[
4
]
,
C
Select the contrast and confirm
Setting the time and date
y
or
z
e.g.:
[
15
]
,
C
Set the hour and confirm
y
or
z
e.g.:
[
31
]
,
C
Set the minute and confirm
y
or
z
e.g.:
[
28
]
,
C
Set the day’s date and confirm
y
or
z
e.g.:
[
11
]
,
C
Set the month and confirm
If you want to change these settings at a later date, press and hold the
y
button
for 4 seconds.
