AUDIOLINE TEL28, Руководство по эксплуатации

Страница: 27 / 32

- Using T-NET / Private exchanges -
27
6 Using T-NET / Private exchanges
You can use the “R” signal button on your telephone on private exchanges and
when using DEUTSCHE TELEKOM’s T-Net functions.
6.1 “R” Button on private exchanges
If you have connected your telephone to a private exchange, you can use all the
facilities such as call transfer, automatic recall, etc. The “R” signal button gives
you access to these facilities. The FLASH time “100ms” will be required on a
private exchange. For this purpose, set the “FLASH” switch to the “100ms”
setting. You can find out from the dealer from whom the equipment was
purchased whether your telephone will work on your private exchange without any
problems and what further facilities you will receive from this.
6.2 “R” Button and the DEUTSCHE TELEKOM T-NET
functions
Your telephone supports the most important DEUTSCHE TELEKOM added value
functions (e.g. brokering, call waiting, three-way conference, etc.). The T-NET
works using the "FLASH 300ms" setting. For this purpose, set the “FLASH” switch
to the “300ms” setting. Please contact DEUTSCHE TELEKOM to gain access to the
T-NET functions (some of which are subject to charge).
6.3 Dialling and storing telephone numbers when using
on private exchanges
Note! The pause function between the code for the outside line (usually 0 or 9)
and the dialling tone described in this chapter is only necessary on older private
exchanges.
With some private exchanges, there is a short pause between the code for the
outside line (usually 0 or 9) and the dialling tone. This pause can be entered when
dialling manually and when dialling from the phone book so that the following
numbers are not dialled too quickly.
Entering the pause when dialling manually
Press the redial button
once between the code for the outside line and the
actual telephone number. After an outside line has been obtained, you telephone
will wait for 3 seconds before dialling the actual telephone number.
Storing the pause with the number
Simply press the redial button
after the code for the outside line and before
the actual telephone number when storing the number. When dialling from the
phone book, a pause of three seconds will then be automatically inserted after the
code for the outside line.